Say hello to Mr Confident. This Cockpot is one of the original designs created from a 3D scan of a good friend from Halifax, NS. He's a tall, fit, artsy boy, with a lot of confidence below the belt. We both studied Fine Arts at NSCAD University, and he enthusiastically offered to be scanned for a pot when I first got the idea for a school project. He is now a fan favourite.
Material: 3D printed PLA (a plant-based plastic)
Colours: White, Black, Stone, Tan, and Pink. (DM on insta for custom colour inquiries)
Uses: Fill them with plants, dried flowers, toiletries, art supplies, office supplies — you name it.
Notes: These pots are art pieces made in my home studio, not mass produced by a factory or print farm. Each pot takes between 6 and 15 hours to print and is printed layer by layer from the bottom up. This layered process is visible up close and is part of the design! Cockpots are NOT ceramic. Plants are not included. Pots may not be 100% water-tight, so water with caution. Each pot also features a drainage hole in the butt. ;)
Care Instructions: Keep away from hot surfaces 60 Celsius/140 Fahrenheit as this can cause PLA to soften and risk deforming. Avoid contact with sharp or rough surfaces, PLA can get scuffed if rubbed against! Not food-safe. And make sure to give your Cockpot lots of attention :)
